Advertisement
17. Install fuel tank and connect fuel line to
petcock and secure with provided pinch
clamp. Refer to figure 1. Do not bolt tank in
place, as minor adjustments may be
necessary.
18. Turn fuel petcock to "on" and check for
leaks.
19. Open throttle 3-5 times to prime accelerator
pump. Do not open throttle any more than
5 times as this may flood engine!!
20. Once pump is primed, get motor to TDC and
kick through without opening throttle. If
Motor will not fire with a few kicks, open idle
cable
turn and repeat starting process.
NOTE: If flooding occurs, slowly open
throttle to wide open and hold. With
throttle still open, hold decompression
lever and kick motor through 5-10 times.
Release throttle and decompression lever
and proceed with normal starting
procedure.
For any questions regarding tuning or
installation of Edelbrock products, please
call our toll free tech line M-F 8:00am-12:
30pm, 1:30pm-5:00pm PST.
877-888-7504 ext.2.
Edelbrock #3115 XR650R
Carburetor Specifications
Bore Size: 36mm Tall X 42mm Wide
Needle: 19E @ 18 Clicks
Accelerator Pump Bypass: 1.5 turns out
Alternate Needles: 17E, 21E
Replacement Cables: #9345
Advertisement
