Table of Contents
Advertisement
Analog Direct Inward Dial (DID) Interface Cards
Figure 17
VIC
4FXS/DID
Connecting an Analog DID Interface Card
Use a standard straight-through RJ-11 modular telephone cable to connect the VIC-2DID or
VIC-4FXS/DID interface card to a PSTN or PBX.
Install the grounding lug on the router. See the hardware installation guide for your router for detailed
Step 1
instructions. (Grounding on the Cisco 1700 series routers is done on the router chassis, and does not need
a grounding lug.)
Confirm that the router is still turned off.
Step 2
Connect one end of the straight-through RJ-11 cable to an RJ-11 port on the card. (See
Step 3
Figure 18
VIC
DID
Straight-through
RJ-11-to-RJ-11 cable
The VIC-2DID or the VIC-4FXS/DID interface cards may be damaged if connected to a standard PSTN
Caution
line. Ensure that lines to the PSTN are provisioned for DID.
Step 4
Connect the other end of the cable to a telephone wall outlet or to a PBX.
OL-12847-01
14
4-Port Analog FXS/DID Voice Interface Card
3
2
1
Connecting an Analog DID Interface Card
RJ-11 ports
1
SEE MAN UAL BEF ORE INST
0
ALLA TION
Connecting Voice Interface Cards to the Network
0
IN USE
RJ-11 wall jack
Figure
18.)
Advertisement
Table of Contents
