Usb; Ide Support - Intel BLKD945GCPE - LGA775 1066FSB 2DDR2 2GB Audio Video Lan mATX 10Pack Motherboard Technical Product Specification

DVMT will always use a minimal fixed portion of system physical memory (as set in the
BIOS Setup program) for compatibility with legacy applications. An example of this
would be when using VGA graphics under DOS. Once loaded, the operating system
and graphics drivers allocate additional system memory to the graphics buffer as
needed for performing graphics functions.
NOTE
The use of DVMT requires operating system driver support.
1.5.1.3 Configuration Modes
A list of supported modes for the Intel GMA950 graphics controller is available as a
downloadable document.
For information about
Supported video modes for the board
1.5.2

USB

The board supports up to eight USB 2.0 ports, supports UHCI and EHCI, and uses
UHCI- and EHCI-compatible drivers.
The ICH7 provides the USB controller for all ports. The port arrangement is as
follows:
• Four ports are implemented with dual stacked back panel connectors
• Four ports are routed to two separate front panel USB headers
NOTE
Computer systems that have an unshielded cable attached to a USB port may not
meet FCC Class B requirements, even if no device is attached to the cable. Use
shielded cable that meets the requirements for full-speed devices.
For information about
The location of the USB connectors on the back panel
The location of the front panel USB headers
1.5.3

IDE Support

The board provides three IDE interface connectors:
• One parallel ATA IDE connector that supports two devices
• Two serial ATA IDE connectors that support one device per connector
Product Description
Refer to
Section 1.2, page 15
Refer to
Figure 8, page 37
Figure 9, page 38
19