Table of Contents
Advertisement
Fig. 7 Options during a
call.
Go to Menu→
Settings→
Call
divert.
18
Copyright © 2004 Nokia. All rights reserved.
Mute
or Unmute,
End active
Private,
Drop
participant, Answer, and Reject.
Swap
is used to switch between the active call and the call on hold.
Transfer
is used to connect an incoming call or a call on hold with an active call and to
disconnect yourself from both calls.
Send DTMF
is used to send DTMF tone sequences, for example, passwords or bank account
numbers.
You may not have all of these options. Contact your service provider for more details.
1 Key in the digits with
is transmitted while the call is active. Press
a pause of approximately two seconds before, or between DTMF characters.), and w (if
you use this character, the remaining sequence is not sent until you press
during the call). Press
2 To send the tone, press OK.
Call waiting (Network Service)
If you have activated the Call waiting service, the network will notify you of a new
incoming call while you have a call in progress.
1 During a call, press
to answer the waiting call. The first call is put on hold.
To switch between the two calls, press Swap.
2 To end the active call, press
Diverting calls (Network Service)
When this network service is activated, you can direct your incoming calls to another
number, for example, to your voice mailbox number. For details, contact your service
provider.
call,
End all
calls,
Hold
or Unhold,
-
. Each keystroke generates a DTMF tone, which
repeatedly to produce: *, p (inserts
to produce #.
.
New
call, Conference,
Send
again
Advertisement
Table of Contents
