After Sales Service; Changing A Water Filter Cartridge - Whirlpool WSF5574 A+N Instructions For Use Manual

CHANGING A WATER FILTER CARTRIDGE

(where provided)
1. Locate the water filter cartridge cap below the freezer compartment door. Rotate the cap
counterclockwise to a vertical position and remove the filter from the base grille.
2. Pull the cap and filter cartridge out through the base grille.
3. Remove the cartridge cap by sliding it off the end of the old cartridge. DO NOT DISCARD THE CAP .
4. Slide the cartridge cap onto the new cartridge.
5. With the cartridge cap in the vertical position, insert the new filter cartridge into the base grille until it
stops.
6. Rotate the cartridge cap clockwise to a horizontal position. RUN WATER THROUGH THE DISPENSER
UNTIL THE WATER RUNS CLEAR (about 9-14 litres or 6-7 minutes). This will clean the system and
clear air from the lines.
Note: As air is cleared from the system, water may spurt out of the dispenser.
Ordering replacement filters
To order more water filter cartridges, please contact the After-sales Service..
AFTER-SALES SERVICE
Before contacting the After-Sales Service:
Switch the appliance on again to see if the problem
has been solved. If it has not, disconnect the
appliance from the power supply and wait for
about an hour before switching on again.
If the appliance is still not working after you have
gone through all the checks listed in the
troubleshooting guide and switched it off then on
again, contact the After-Sales Service to explain the
problem and have the following information ready:
• The nature of the fault
• The appliance model
• The type and serial number of the appliance
(stated on the rating plate)
• The Service number (the number after the word
SERVICE on the rating plate inside the
appliance)
Note:
The doors of the appliance can be removed. If
this operation is performed by the After-sales
Service it is not covered by the warranty.