Table of Contents
Advertisement
• Do not install and connect a damaged
appliance.
• Make sure to remove all packaging and
transport bolts.
• Make sure that the mains plug is dis-
connected from the mains socket dur-
ing installation.
• Only a qualified person must do the
electrical installation, the plumbing and
the installation of the appliance. This to
prevent the risks of structural damage
or injury.
• Do not install or use the appliance
where the temperature is less than 0 °C.
• When you install the appliance on a
carpet floor, make sure that there is air
circulation between the appliance and
the carpet. Adjust the feet to have the
necessary space between the appliance
and the carpet.
Water connection
• Do not connect the appliance with old
hoses already used. Only use new ho-
ses.
• Make sure not to cause damage to the
water hoses.
• Do not connect the appliance to new
pipes or pipes not used for a long time.
Let the water flow for some minutes,
then connect the inlet hose.
• The first time you use the appliance,
make sure that the water hoses and the
couplings do not have leakages.
Electrical connection
• Make sure that the appliance is earth-
ed.
• Make sure that the electrical informa-
tion on the rating plate agrees with the
power supply.
• Always use a correctly installed shock-
proof socket.
TECHNICAL INFORMATION
Dimensions
• Do not use multiple plugs and exten-
sion cables. There is a risk of fire.
• Do not replace or change the mains ca-
ble. Contact the service centre.
• Make sure not to cause damage to the
mains plug and cable.
• Connect the mains plug to the mains
socket only at the end of the installa-
tion. Make sure that there is access to
the mains plug after the installation.
• Do not pull the mains cable to discon-
nect the appliance. Always pull the
mains plug.
• Only for UK and Ireland. The appliance
has a 13 amp mains plug. If it is neces-
sary to change the fuse in the mains
plug, use a 13 amp ASTA (BS 1362)
fuse.
• Permanent connection. To connect
the appliance permanently, install a
double-pole isolating switch between
the appliance and the electricity supply.
It must have a minimum distance of 3
mm between the switch contacts and it
must be the correct type for the neces-
sary load. It must agree with the last
electrical legislation. The switch must
not break the yellow and green ground
cable.
Only a qualified electrician must install
this type of device.
DISCARD THE APPLIANCE
1.
2.
3.
Width / Height / Depth
Total depth
Disconnect the mains plug from the
mains socket.
Cut off the mains cable and discard it.
Discard the door catch. This prevents
children or pets to be closed in the
appliance. There is a risk of suffoca-
tion (only for front-loading applian-
ces).
600 / 820 / 630 mm
ENGLISH
5
640 mm
Advertisement
Table of Contents
