Samsung WF433BTGJWR/A1 Technical Information page 7

ALIGNMENT AND ADJUSTMENTS
To avoid risk of electrical shock, personal injury or death; disconnect power to washer
before servicing, unless testing requires power.
Quick Spin Test Mode
While it is not in Hold Speed Mode
Definition of Quick Spin Test Mode:
- Quick Spin Test Mode is to do Spin Check. (High RPM)
How to Enter:
- During Service Mode, press the Delay Start + Rinse Add Keys for 3 seconds to enter Quick Spin
Test Mode.
- Cannot enter once the washing cycle has started.
Quick Spin Test Mode:
As it enters into the Quick Spin Test Mode, it starts spinning and reaches to its maximum RPM.
Once the Spin speed reaches the maximum RPM, the speed drops immediately.
To hold Quick Spin Test Mode (entering Hold Speed Mode), press the Start/Pause button. If the
Start/Pause button is pressed during Quick Spin Test Mode, it will stop accelerating and hold its
spinning speed for 10 minutes before going back to Quick Spin Test Mode.
Also, to cancel the hold and allow Quick Spin Test Mode to continue, press the SPIN Key If you
PressSPIN key when the washing machine is not in Hold Speed Mode, Quick Spin Mode is exited
and Service Mode is restored.
(Techsheet)WF433GJ-03152C_EN_20120621.indd 7
WARNING
Service Mode
Delay Start + Rinse Add
Delay Start + Rinse Add
3 sec
While a cycle is not running
Quick Spin Test Mode Start/Pause Hold Speed Mode
Delay Start + Rinse Add for 3sec or after 10 minutes
7
2012-06-21 12:12:39