Configuring P-Class Blade Gbe2 Server Enclosure Interconnects; Disabling A Port; Interconnect Telnet Session - Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual

Figure 41 Disabling a port
5.
Click Submit
Verifying VLAN settings
After disabling the XConnects, verify that each port used in the iSCSI setup is enabled and is part
of the same VLAN. To verify:
1.
From Windows Start, select Run.
2. Enter "telnet" in the Run dialog box.
3.
Log in to Interconnect A or B and run the command "show vlan"
NOTE:
All ports are members of the same VLAN and are in VLAN 1 by default.
Verify the VLAN settings for Interconnects A and B.
Figure 42 Interconnect telnet session
Configuring p-Class Blade GbE2 server enclosure interconnects
This section describes a configuration example using GbE2 interconnects. For details on the configuration
or installation of the interconnects, see the specific Blade server documentation.
Setup
Using the setup instructions in the HP ProLiant BL p-Class GbE2 Interconnect Switch Application Guide,
enable the Browser-Based Interface (BBI). Access the configuration management and operation features of
the switch through the BBI and your Web browser. Use the web interface to disable the cross connection
(Figure 41).
(Figure 42).
C-Series iSCSI 45