Virtual Targets Defined For Host; Log On To Target Window - Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual

Figure 34 Virtual targets defined for host
2. Select a target and click Log On....
The Log On to Target window opens
Figure 35 Log On to Target window
3.
Select the Automatically restore this connection when the system boots and the Enable multi-path
check boxes to ensure that the controller port is enabled as a persistent target and is able
to utilize multi-pathing
4.
Click OK.
5. Repeat Steps 2 through 4 for all available virtual targets.
The Targets tab should now display the status for both storage controllers as Connected
(Figure 35).
(Figure 35).
(Figure 34).
C-Series iSCSI 39