Virtual Targeting; Iscsi Initiator Zoned With An Eva Storage Port; The Targets Tab - Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual

Figure 31 iSCSI Initiator zoned with an EVA storage port

Virtual targeting

Before the iSCSI Initiator can log in to the storage controller, you must create virtual targets on each
C-Series Fibre Channel switch in the iSCSI window.
1.
Using the Cisco Device Manager, select IP > iSCSI from the Device Manager menu bar.
The IP iSCSI window opens
2.
Click the Targets tab
Figure 32 The Targets tab
3. Click
Create.
The Create iSCSI Targets window opens
4. In the Create iSCSI Targets window, enter a name for the iSCSI Name box.
5. Select the target storage port from the Port WWN list.
6.
Under Initiator Access, select an Initiator. Select All if the list is empty.
7.
Under Advertised Interfaces, select the port connected to the host iSCSI Initiator.
(Figure 28).
(Figure 32).
(Figure 33).
C-Series iSCSI 37