C-Series Switch Side: Conﬁguring Transparent-Mode Static Mapping; Both C-Series Switches Are Target Portals; Ip Iscsi Window - Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual

Hp storageworks c-series iscsi configuration guide (aa-rw7pe-te, december 2006)

Hide thumbs Also See for AJ732A - Cisco MDS 9134 Fabric Switch:

Table of Contents

Figure 27 Both C-Series switches are target portals

C-Series switch side: conﬁguring transparent-mode static mapping

The iSCSI-enabled C-Series switches have two modes of mapping IP addresses:

•

Transparent-mode dynamic mapping

•

Transparent-mode static mapping

You must enable static mapping for each iSCSI Initiator for persistent LUN mapping from the Fibre

Channel storage controller.

Using the Cisco Device Manager, select IP > iSCSI from the menu bar.

The IP iSCSI window opens

Figure 28 IP iSCSI window

Clear the Discovery Dynamic check box

(Figure

28).

(Figure

29).

C-Series iSCSI

Table of Contents