Echo CS-330T Instruction Manual page 8

K
J H
p
RepaRation foR
KICK GUARD® TO BAR INSTRUCTIONS
For saws with Kick Guard
cal or asymmetrical low-kick type guide bars.
1. Install bolt (A) in rear hole (B) of Kick Guard
through front hole (C) in guide bar.
2. IMPORTANT: Dimple in Kick Guard
recess in guide bar (E).
3. Tighten nut (F) and bolt (A) until snug. Make certain
Kick Guard
GUIDE BAR AND SAW CHAIN-INSTALL/ RE-
MOVE
G
Saw Chain is sharp! Always wear gloves when handling
assembly, otherwise serious personal injury may result.
1. Move chain brake lever (G) fully rearward to unlock
chain brake.
IMPORTANT
Always loosen guide bar nuts before turning chain
tension adjuster, otherwise clutch cover and tensioner
will be damaged.
2. Remove two guide bar nuts (H). Turn tension
adjustment screw (J) counterclockwise 2 to 3 turns if
bar and chain are installed.
M
3. Push clutch cover (K) forward, pull rear of cover out
slightly, then remove.
4. Remove guide bar and saw chain if necessary.
L
NOTE: See "MAINTENANCE AND CARE"
instructions for guide bar, sprocket, and saw chain
maintenance.
N
5. Mount guide bar (L) on studs, and slide toward
sprocket to make saw chain installation easier.
Install saw chain (M) over clutch and place around
sprocket and guide bar as shown, with cutters on
top of guide bar facing forward.
6. Align holes of clutch cover (K) with guide bar studs,
and tensioner pin (N) with lower guide bar adjuster
hole. Install cover, then press and hold rear of cover
to fully seat. Tighten guide bar nuts finger tight.
8
u
se
®
P/N 2894901 and symmetri-
®
is flush against guide bar.
WARNING
®
and
®
(D) must engage