Supplied Accessories - Sharp LC-20SH6U Operation Manual

Supplied Accessories
300-ohm twin-lead cable (flat)
r
F-type connector
---II-
75-ohm coaxial cable (round)
1. A 75-ohm system is generally a round cable with F-type connector that can easily
be attached to a terminal without tools (not supplied).
2. A 300-ohm system is a flat "twin-lead" cable that can be attached to a 75-ohm
terminal through a 300175-ohm adapter (not supplied).
•.
nIl3Mn·~j
• The antenna requirements for good color television reception are more important than those for black & white television
reception. For this reason, a good quality outdoor antenna is strongly recommended.
The following is a brief explanation of the type of connections that are provided with the various antenna systems.
(LC-13SH6U)
Make sure the following accessories are provided with the
LCD
TV set.
OUTDOOR ANTENNA CONNECTION
Preparation
;.....-~_--;-
ANT. (Antenna
terminal)
F-type connector should be finger-tightened only.
When connecting the RF cable to the LCD TV set, do not tighten F-type
connector with tools.
.If tools are used, it may cause damage to your
LCD
TV set.
(The breaking of internal circuit, etc.)
~ ~
Antenna cable
(commercially available)
B. Separate VHF and/or
UHF Antennas
a~~rfna
VHF
30.0-~hrn
antenna
twin-lead
Combiner \ /
(not SUPplied~ fQO-~hrn
~ UT
IN
tw=in=-:;gea~~~
&g~Jr
cable
cr
{liD '
A. Combination VHF/UHF Antenna
300f75-ohm
L adapter
(not supplied)
VHF/UHF
VHF/UHF antenna
=:#
antenna
J
300-ohm
' t c-
or
twin-lead
75-ohm
,L
coaxial cable
L+
• Use one of the following two diagrams if you connect an outdoor antenna.
A: Using a VHF/UHF combination outdoor antenna
B: Using separate VHF and/or UHF outdoor antennas
• Connect the outdoor antenna cable lead-in to ANT. (Antenna terminal) on the rear of the main unit.
•
~
tl)
i
tiJ
=-
F-type connector
~i~
~~~
75-ohm coaxial cable /
o
Align the tab on the battery cover (CD) and place
it while pressing the tab (®) to close it.
~
:••. . • . • . . . p . . • . . . . . . . • . • . . : • . . • . : . . • : . : • . : . : : . : . . • • . • :
®~
- . .
/& : • . . . . . . . . . . : . . : . • . . • . : : . . . . • . . • . : . : . . . . . • • . • . . . . • . . . • : . : . • : :. o
0 . . . . : . : . .
~
C1::;,*
--= ~ . ~ /
~
o ,:,
:+:
~
: . : • . : . • • . . . . . •
$ : . • . . • •
~
~~
e~
/
o
Detach the cover
while pressing the
(T)
part.
Cautions regarding use of the remote control
o
Do not apply shock to the remote control. In addition, do not
expose the remote control to liquids, and do not place it in an area
with high humidity.
o
Do not install or place the remote control under direct sunlight. The
heat may cause deformation of the unit.
o
The remote control may not work properly if the remote sensor
window is under direct sunlight or strong lighting. In such a case,
change the angle of the lighting or main unit, or operate the remote
control closer to the remote sensor window.
o
Place batteries with their
terminals corresponding
to the (+) and (-)
indications in the battery
compartment.
Precautions regarding batteries
Improper use of batteries can result in a leakage of chemicals and/or explosion. Be sure to follow the instructions below.
o
Place batteries with their terminals corresponding to the (+) and (-) indications.
o
Different types of batteries have different characteristics. Do not mix batteries of different types.
o
Do not mix old and new batteries. Mixing old and new batteries can shorten the life of new batteries and/or cause old
batteries to leak chemicals.
o
Remove batteries as soon as they are depleted. Chemicals that leak from batteries can cause a rash. If chemical
leakage is found, wipe it off with a cloth.
o
The batteries supplied with the LCD TV set may have a shorter operating time due to storage conditions.
o
If the remote control is not to be used for an extended period of time, remove the batteries from the remote control.
Use the remote control by pointing it towards the remote sensor
window of the main unit. Objects between the remote control and
sensor window may prevent proper operation.
Before using the LCD TV set for the first time, install the two "AAA" size batteries (supplied) in the remote control. When the
batteries become depleted and the remote control fails to operate, replace the batteries with new "AAA" size batteries.
1
Open the battery cover.
2
Insert two "AAA" size batteries.
3
Close the battery cover.