Connect The Power Supply - LaCie LaPlug Quick Install Manual

Installation
1. Connect the Ethernet cable to the
product and to your local network
(network hub, switch, or router).

2. Connect the power supply.

3. Push the power button until the front
LED blinks blue. Release the button
and the product will boot, which
may take up to two minutes. When
the light becomes steady blue, the
product is ready to use.
4. Install and run LaCie Network Assistant,
located on the CD-ROM.
Note: If you want to turn off the drive, press and hold the power button for 5 seconds until
the LED blinks blue. When the LED turns off, the drive has shut down.
Router or Hub
OUT IN
Fig. 1
Fig. 2
Fig. 3