Equipment Check; Emission Control - Echo PB-251 Operator's Manual

6

EQUIPMENT CHECK

Use only ECHO approved attachments. Serious injury may result from the use of a non-approved attachment
combination. ECHO, INC. will not be responsible for the failure of cutting devices, attachments or accessories which
have not been tested and approved by ECHO. Read and comply with all safety instructions listed in this manual and
safety manual.
• Check unit for loose/missing nuts, bolts and screws. Tighten and/or replace as needed.
• Inspect fuel lines, tank and area around carburetor for fuel leaks. DO NOT operate unit if leaks are found.
• Do not use blower if any part is missing or damaged.
• Have repairs done only by an authorized ECHO Service dealer.
• Do not use any attachment, accessory or replacement part unless it is recommended in this Operator's Manual.
E C
MISSION ONTROL
EPA Phase 2
The emission control system for these engines is EM/TWC
An Emission Control Label is located on the unit. (This is an EXAMPLE ONLY; information on label varies by engine
FAMILY).
The 300 hour emission durability compliance period is the time span selected by the manufacturer certifying the
engine emissions output meets applicable emissions regulations, provided that approved maintenance procedures
are followed as listed in the Maintenance Section of this manual.
WARNING
(Engine and Catalyst Modification).
IMPORTANT ENGINE INFORMATION
ENGINE FAMILY: 6EHXS.0254KF DISPLACEMENT: 25.4
EMISSION COMPLIANCE PERIOD : 300 HRS.
THIS ENGINE MEETS U.S. EPA PH2 EXHAUST
EMISSION REGULATIONS FOR SORE. REFER TO
OWNER'S MANUAL FOR MAINTENANCE SPECIFI-
CATIONS AND ADJUSTMENTS.
PRODUCT EMISSION DURABILITY
CC