Starting Warm Engine - Echo PB-251 Operator's Manual

12
IMPORTANT
Recoil starter: Use short pulls - only 1/2 ~ 2/3 of rope for starting.
Do not allow the rope to snap back in. Always hold the unit
firmly.
5. Recoil Starter
Place the unit on a flat, clear area. Firmly grasp throttle grip with
left hand and rapidly pull recoil starter handle/rope (E) until engine
fires , or maximum 5 pulls.
6. Choke
move choke lever (C) to Run (
engine.
NOTE
If engine does not start after 5 pulls, repeat instructions 3-6.
7. After engine warm up, gradually depress throttle trigger to
increase engine RPM to operating speed.
NOTE
Allow engine to warm up before use.

STARTING WARM ENGINE

The starting procedure is the same as Cold Start except DO NOT close
the choke.
1. Stop Switch
Move stop switch button (A) away from the STOP position.
2. Throttle Position Lever
Move throttle position lever (B) midway between idle and full
throttle positions.
3. Purge Bulb
Pump purge bulb (D) until fuel is visible and flows freely in the
clear fuel tank return line.
4. Recoil Starter
Place the unit on a flat, clear area. Firmly grasp throttle grip with
left hand and rapidly pull recoil starter handle/rope (E) until engine
fires.
IMPORTANT
Recoil starter: Use short pulls - only 1/2 ~ 2/3 of rope for starting.
Do not allow the rope to snap back in. Always hold the unit
firmly.
NOTE
If engine does not start after 5 pulls, use Cold Start Procedure.
) position if necessary, restart
E
C
A
B
E
D