Application Example For Stp Function - TP-Link JetStream L2 Lite TL-SG3210 User Manual

The following entries are displayed on this screen:
TC Protect
TC Threshold:
TC Protect Cycle:

7.5 Application Example for STP Function

Network Requirements
Switch A, B, C, D and E all support MSTP function.
A is the central switch.
B and C are switches in the convergence layer. D, E and F are switches in the access layer.
There are 6 VLANs labeled as VLAN101-VLAN106 in the network.
All switches run MSTP and belong to the same MST region.
The data in VLAN01, 103 and 105 are transmitted in the STP with B as the root bridge. The
data in VLAN02, 104 and 106 are transmitted in the STP with C as the root bridge.
Network Diagram
Configuration Procedure
Configure Switch A:
Step Operation
Figure 7-11 TC Protect
Enter a number from 1 to 100. It is the maximum number of the
TC-BPDUs received by the switch in a TC Protect Cycle. The
default value is 20.
Enter a value from 1 to 10 to specify the TC Protect Cycle. The
default value is 5.
Description
87