Advertisement
Charging the Belkin TunePower
To charge the Belkin TunePower, connect the small end of the included AC wall
charger into the DC-power-in jack on the side of the TunePower. Connect the AC wall
charger into any US wall power outlet.
The LED charge indicator will illuminate green when the Belkin TunePower is
charging its batteries. This indicator will turn off when the battery has been charged
to approximately 90 percent.
The TunePower will charge its batteries completely in approximately four hours.
The Mobility Kit for Xpress and RoadyXT is fully operational while the TunePower
is charging.
Note: The Belkin TunePower XM will supply power to the XM Plug-n-Play receiver
whenever its dock connector is connected. When not in use, it is recommended to
disconnect the Belkin TunePower XM from the XM Plug-n-Play receiver or make sure
that the XM Plug-n-Play receiver is turned off to conserve power.
7
Advertisement
