Yamaha YHT-F1500 - Home Theater in a Box Quick Connect Manual

Quick-Connect Guide
YHT-F1500
Home Theater in a Box

Your System

1



Inspect Contents After unpacking, inspect the contents to confirm you have the above items:
speakers, three surround speakers, one front center speaker,
 
stands, two finishing brackets, RCA cable, one bag each of
 
center speaker bracket and screw, powered subwoofer,

remote control, DV-SL100 DVD Player with remote control,

and cable protection seal for base. Also included, but not shown, are 6 pairs of colored cable tags, AM and FM

antennas and three related Owner's Manuals.
3
Main Speaker Assembly
Attach Bases to Stands Apply the non-skid pads
inset. Identify both speaker stands and both bases

short screws as shown.

6
Connect Front Main Speaker
Wire For illustration purposes, stand,
which is now attached to speaker, is not
shown in diagram above. Locate screw-
type input terminals at the rear of each of
the speakers. Connect the speaker wire as
shown. The positive (+) side of the wire
with the white stripe attaches to the red
terminal. The negative (-) side attaches to
the black terminal. (Please see your NS-
AP9500 Owner's Manual for more detailed
instructions on speaker wire connections.)
Place assembled main speakers in desired
location to the left and right of the viewing/
audio source. (See Step 2, Room Layout.)
NOTE Banana plug connectors (not
included) can be used to connect speaker
wire to speaker terminals. Please see your
Owner's Manual for directions.




bulk speaker wire, two bases,
 
long screws (8) and short screws (4),
 
audio/video RCA cable, RX-SL100 A/V Receiver with
 
non-skid pads for base, non-skid pads for stands,
 
4
as shown in the

and attach using

7
Rear
Speakers
Mount Surround Speakers and Surround Back Speaker Fasten mounting screws into a
firm wall or wall support as shown. Hang the keyholes on the back of the each of the speakers
the protruding screws. Attach speaker wire as shown in Step 6.
���� �������
2
two main
two speaker

front

Speaker Placement After assembly of the speakers place them so they appear in the approximate positions as
shown in the diagram above.
5
Thread Speaker
Wires Cut
speaker wire to

appropriate lengths
for all speaker
connections and
set aside. Place
each long stand
upright on its base.
Thread main speaker
wire through
oval opening on
stand and pull
through opening
on underside of
base. Pull wire all
the way through
leaving extra length
near oval opening
as shown. Attach
color cable tags to
all speaker wires as
shown in Step 10.
Apply non-skid pads
on stands.


��� ���
8
Attach Finishing Brackets
9
Front Center Speaker Assembly
on
Attach Bracket and Speaker Wire Attach bracket
speaker using supplied screw as shown. Attach speaker wire as shown

in Step 6.
Room Layout
Attach Main
Speakers Lay stands
down. Line up holes
so that oval opening
is near speaker wire
connections on speaker.
Attach main speakers
using long screws as
shown. Attach cable
protection seal to

base as shown in inset.
on top of two speaker stands.

to center
