Hotpoint HDA3600RCC - 24" Dishwasher Installation Instructions Manual page 14

Dishwasher Installation
STEP 19: DISHWASHER WET TEST
CHECKLIST
[] Turn on power supplg or if power cord is used,
plug it into the wall outlet
[] Latch dishwasher door
[] For electronic dishwashers, select the NORMAL
WASH cgcle and press the START pad one time
C_J_s Options c_,,_
U ii@
IS(.........................................
[] For dial models, press the NORMAL and HOT
START pads, if model has them, and then turn the
control dial just enough to start the dishwasher
Be careful not to turn the dial past the first water
fill Dial should point to "Hot Start Option" or "Hot
Prewash Option" depending on model
- Check the electrical connection to the water
valve The red electrical connector should be
plugged into the dishwasher water valve If it
is not plugged in, turn off electrical power to
the dishwasher Plug the red connector into the
dishwasher water valve and then restore power
RedConnector
Hot Start
Option Start
Cucles Options 4. "
StartDelau%q, ....
Cycle (MRS)
• Off o Light Wash
Pots Hear u Hi-Temp Heated Reset (Heated Dru On)
Po_ os os oru
Ri_se OnlL
(Heated Dru _ffl
Appearance varies by model. Not all models have push buttons.
[] Check to be sure that water enters the
dishwasher This could take up to/4 minutes
If water does not enter the dishwasher:
- Check to be sure that the water is turned on
- Lightly tap the flood float cover to dislodge
a stuck flood float
Cover
[] Check for leaks under the dishwasher Ifa leak is
found, turn off power, tighten connections and
restore power
[] Check for leaks around the door A leak around
the door could be caused b U the dishwasher door
rubbing or hitting adjacent cabinets Reposition
the dishwasher if necessar U See Steps 11, 12
and 13.
[] Host dishwasher models will drain about
3 minutes after the first fill Check the drain line
for leaks when dishwasher drains If leaks are
found, turn off power, correct as necessar U
and then restore power
[] Open the dishwasher door and make sure most
of the water has drained If the water does not
drain, check to be sure disposer plug has been
removed and/or air gap is free of debris
[] Let the dishwasher run through another fill and
drain cycle Check again to be sure there are no
leaks
[]
At the end of the second drain, push the reset pad
on electronic models For dial models, unlatch the
door and rotate the dial to the "Off" position
14