Table of Contents
Advertisement
Dishwashing
Time remaining
Once you have selected a program and options, the
display indicates how long the program took the last
time it was used. The remaining time is updated after
the water for the final rinse has been heated.
This may differ somewhat from time to time depending
on the temperature of the water supply, the amount of
dishes, the ambient temperature, and other factors.
NOTE!
During the first run of each program, the remaining
time displayed can be slightly misleading, as the
dishwasher is estimating the time. When you run the
program a second time, the dishwasher will calculate
the remaining time based on the previous duration of
the program.
Stopping or changing a program
If you want to change programs after starting the
dishwasher, open the door then press and hold
Start/Stop for three seconds. Add more detergent if the
lid of the detergent dispenser has opened. Then choose
a new program, press Start/Stop, and close the door.
Do you want to add more dishes?
Open the door. The dishwasher stops automatically.
Add the dishes, close the door, and the dishwasher
resumes the program.
If the dishwasher is turned off using the main
power switch or due to a power failure
If the program was not finished, the interrupted program
resumes when power is restored.
NOTE!
During drying, the program is interrupted if the power
is cut or the door is open for more than 2 minutes.
8
After dishwashing
Once the program has finished and the door is
opened, "End" appears on the display.
A buzzer also sounds at the end of the program. See
the section Settings, which describes how to change
this function.
Once the dishwasher has finished, it uses only standby
power. Turn off the dishwasher using the main power
switch if you want to completely cut the power. Turn off
the water supply valve after each use.
Customer Care Center
1-800-898-1879
19
Advertisement
Table of Contents
