Table of Contents
Advertisement
Dishwashing
6
Select options
To select an option, press one of the option
buttons. The field under the button lights when
the option is activated. The available options depend
on the selected program. Once you have started the
program, the options you selected are saved for the
next time you use the same program. An exception is
the Delayed start option.
High temperature
Activate this option for improved dishwashing results.
The machine then uses a higher temperature for the
main wash. This option cannot be activated if the Time
saver option is selected.
If you want to use the lower temperature, press again
so that the field under the button turns off.
You can vary the temperature as shown below:
Platters & Pans:
Normal wash:
Everyday ware:
Quick wash:
Refresh wash:
Glass wash:
Eco wash:
Long dry
A higher temperature in the final rinse and a longer
drying phase improves the drying result if you activate
the Long dry option. This causes a slight increase in
energy consumption. This option can be used with all
programs except Time program, Rinse & Dry, and Rinse
& Hold. This option cannot be activated if the Time saver
option is selected.
If you want a program with Short dry, press again so
that the field under the button turns off.
18
130 °F (55 °C)/ 160 °F (70 °C)
130 °F (55 °C)/ 150 °F (65 °C)
140 °F (60 °C)/ 150 °F (65 °C)
85 °F (30 °C)/ 140 °F (60 °C)
85 °F (30 °C)/ 140 °F (60 °C)
105 °F (40 °C)/ 120 °F (50 °C)
120 °F (50 °C)/ 140 °F (60 °C)
Delayed start
When you select Delayed start, the dishwasher will start
1-24 hours after you press the Start/Stop button.
1. Press the button once to activate Delayed start.
Press the button several times – or hold it in – to set
the desired number of hours.
2. Press Start/Stop and the dishwasher counts down
1 hour at a time and starts after the selected delay.
Press and hold Start/Stop for three seconds if you want
to cancel the Delayed start option.
NOTE!
Remember to press the Start/Stop button to start the
program.
Set time
Press the option button several times – or hold it in – to
set the desired program time for Time program. You
can choose a program time between 30 minutes and 3
hours.
Time saver
This option shortens the program time, but uses more
energy and water. This option can be selected with the
Platters & Pans, Normal wash, and Everyday ware
programs.
7
Press Start/Stop and close the
door
The display flashes three times with the
remaining time to indicate that the program has started.
Close the door properly, otherwise the dishwasher will
not start. The display indicates
NOTE!
If the machine does not start within 2 minutes of the
last button press, the display returns to showing the
last program run.
Customer Care Center
1-800-898-1879
if the door is open.
Advertisement
Table of Contents
