Table of Contents
Advertisement
TROUBLESHOOTING
■ Remote control
Problem
The remote control does not work
and/or function properly.
You cannot operate external
components with this unit's
remote control.
The cursor buttons do not work
during SET MENU operation.
You cannot use the my beam auto-
adjust function.
84
En
Cause
Wrong distance or angle.
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit.
The batteries are weak.
The external component you want to
operate is not selected as the input
source.
The remote control code was not
correctly set.
Even if the remote control code is
correctly set, there are some models that
do not respond to the remote control.
The operation mode selector was
unwantedly set to TV/AV.
Wrong distance or angle.
Remedy
The remote control will function within a
maximum range of 6 m (20 ft) and no
more than 30 degrees off-axis from the
front panel.
Reposition this unit.
Replace all batteries.
Press INPUT on the front panel or the
input selector buttons on the remote
control to select the external component
you want to operate.
Set the remote control code correctly or
try another code for the same
manufacturer using the "LIST OF
REMOTE CONTROL CODES" at the
end of this manual.
Use the remote control supplied with the
external component.
Set the operation mode selector to YSP.
The remote control will function within a
maximum range of 6 m (20 ft) and no
more than 30 degrees off-axis from the
front panel.
See
page
22
—
22
37
77
—
—
22
Advertisement
Table of Contents
