Table of Contents
Advertisement
In addition to controlling this unit, the remote control can also operate other A/V components made by YAMAHA and
other manufacturers. To control other components, you must set up the remote control with the appropriate remote
control codes and set the operation mode selector to TV/AV to change the control area.
Note
Depending on the external A/V component you are using, you may not be able to operate the component with the remote control, even
if a remote control code is set. In this case, operate the component using the supplied remote control.
Setting remote control codes
You can control other components by setting the
appropriate remote control codes. Codes can be set up for
each input area (TV, STB, DVD, VCR and AUX).
For a complete list of available remote control codes, refer
to "LIST OF REMOTE CONTROL CODES" at the end of
this manual.
STB
TV
VOL MODE
5BEAM
1
STEREO
4
MUSIC
7
OFF
0
CH LEVEL
TEST
VOLUME
MUTE
1
Press and hold CODE SET on the remote
control and then press one of the input
selector buttons to select the input source
you want to set a remote control code for.
The transmission indicator flashes twice and then
remains lit.
Proceed to step 2 while holding down CODE SET.
TV MUTE
While holding
down, press
CODE SET
REMOTE CONTROL FEATURES
VCR
DVD
AUX
TV
INPUT1
INPUT2
MACRO
AUTO
SETUP INPUTMODE
SLEEP
ST+3BEAM
3BEAM
2
3
MY BEAM
SURROUND
5
6
MOVIE
SPORTS
8
9
+10
MENU
TV/AV
ENTER
YSP
RETURN
CH
TV VOL
TV INPUT
TV MUTE
CODE SET
STB
VCR
DVD
AUX
TV
2
Press the numeric buttons to enter the
remote control code while holding down
CODE SET.
Setting example: YAMAHA DVD input area
TV MUTE
While holding
down, press
CODE SET
3
Refer to "Controlling other components" on
page 78 to operate the external component
using the remote control.
If the external component functions correctly, the
remote control code setup was successful.
If the external component does not function correctly,
the remote control code may be incorrect. Confirm
that the remote control code is correct (see "LIST OF
REMOTE CONTROL CODES" at the end of this
manual) and start over from step 1.
Note
If the manufacturer of your component has more than one code,
try each of them until you find the correct one.
If the remote control is without batteries for more than
2 minutes, or if exhausted batteries remain in the
remote control, the contents of the memory may be
cleared. When the memory is cleared, insert new
batteries and reset the remote control codes.
When changing the batteries, be careful not to press
any of the buttons on the remote control. Doing so will
clear the contents of the memory.
REMOTE CONTROL FEATURES
SURROUND
6
SPORTS
9
SPORTS
9
77
En
Advertisement
Table of Contents
