Advertisement
HP LP2065 Flat Panel Monitor
Specifications
Panel type
Viewable image area (diagonal)
Viewing angle
Brightness
Contrast ratio
Response rate
Frequency
Resolutions supported
Input signal
Video cable
User controls (on-screen display)
Built-in power supply
Power consumption
Dimensions (h × w × d)
Weight
Base features
Temperature
Certification and compliance
Warranty
1
The HP Flat Panel Monitor Quick Release has been designed to support a maximum of up to 24 lbs (10.9 kg) depending upon the mounting configuration used. Because mounting surfaces
vary widely and the final mounting method and configuration may vary, mounting fasteners are not supplied (other than the VESA-compliant screws). HP recommends that you consult with a
qualified engineering, architectural or construction professional to determine the appropriate type and quantity of mounting fasteners required for your application and to ensure that your
mounting solution is properly installed to support applied loads.
2
Response time: 8 ms (gray to gray); 16 ms (rise and fall).
© 2005 Hewlett-Packard Development Company, L.P.
Microsoft and Windows are trademarks or registered trademarks of Microsoft Corporation in the U.S. and other countries.
All performance specifications represent the typical specifications provided by HP's component manufacturers; actual
performance may vary either higher or lower. The information contained herein is subject to change without notice. The
only warranties for HP products and services are set forth in the express warranty statements accompanying such products
and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical
or editorial errors or omissions contained herein.
For more information, visit us online at www.hp.com/products/monitors
12/2005
Active matrix TFT (thin film transistor); anti-glare/anti-static coatings
20.1 in (51 cm) maximum viewable area
178° horizontal/178° degrees vertical (10:1 min. contrast ratio) typical
Up to 300 nits (typical)
Up to 800:1 (typical)
8 ms
2
Horizontal: 30 to 94 kHz (VGA input); 30 to 92 kHz (DVI input) (for modes with pixel clock less than 157 MHz)
Vertical: 48 to 85 Hz (VGA input); 30 to 92 kHz (DVI input) (for modes with pixel clock less than 157 MHz)
1600 x 1200 @ 60 Hz (native); all VESA modes up to 1600 x 1200 @ 75 Hz (analog), 1600 x 1200 @ 60 Hz (digital)
Two connectors, dual DVI-I (VGA analog and digital input)
Two VGA to DVI-I and two DVI-D to DVI-I cables included
Brightness, contrast, positioning, color temperature, individual color control, serial number display, full screen resolutions, clock,
clock phase, input selection (includes separate direct access key for dedicated swap between inputs 1 and 2), factory reset
Auto-Ranging, 90 to 132 VAC and 195 to 265 VAC; internal power supply, 50 Hz/60 Hz
< 75 watts maximum; < 2 watts power saving mode; 55 watts (without USB ports); 70 watts (USB ports fully loaded) typical
Without stand: 13.58 x 17.4 x 3.42 in (34.5 x 44.3 x 8.7 cm)
With stand: 16.7 to 21.8 x 17.4 x 8.67 in (42.5 to 55.5 x 44.3 x 22.0 cm)
Packaged: 11.77 x 22.2 x 16.77 in (29.9 x 56.4 x 42.6 cm)
With stand: 20.28 lbs (9.2 kg); Without stand: 12.65 lbs (5.75 kg); Packaged: 26.3 lbs (11.95 kg)
Height adjustment, tilt, swivel, pivot rotation for portrait and landscape viewing
Operating: 46° to 95° F/10° to 35° C; Non-operating: 6° to 140° F/-10° to 60° C
Australian ACA Approval, Canadian Requirements/CSA, CE Marking, China CCIB/CCEE Approval, CISPR Requirements,
Eastern European Approvals, Energy Star Compliant, FCC Approval, German Ergonomic (TUV and GS Mark), ISO 9241-3,7,8
VDT Guidelines, ISO 13406-2 Pixel Defect Guidelines, Mexican NOM Approval, MIC Requirements (New Zealand), MPR-II
Compliant, Nordic Approvals (Nemko, Fimko, Demko, Semko), PC2001 Compliant, PC99 Certified, S. Korean MIC Approval,
Taiwan BSMI Approval, TCO 03 (emissions, ergonomics, environment), TUV-Ergo, UL Listed, VCCI Approvals, Windows
Certification (Microsoft
®
Windows
Three years parts, labor, and on-site service. 24-hour, 90-day, toll-free technical support. Replacement options may include
second business day on-site service, or next business day direct replacement, at HP's sole discretion. With direct replacement, HP
will ship a replacement display product directly to you. Using the prepaid shipping labels provided, return your failed display to
HP in the same packaging as the replacement. Certain restrictions and exclusions apply. For details see your product warranty or
contact HP Customer Support.
®
98, Microsoft Windows 2000, and Microsoft Windows XP)
Advertisement
