Indicators ( Leds ); Buzzer - Epson FX 890 - B/W Dot-matrix Printer Service Manual

1.2.3 Indicators ( LEDs )

This printer has the following indicators to indicate its current condition, as shown in the table
below:
Pause ( Orange )
1.
Comes On when the printer is paused, and goes Off when the printer is not paused.
Blinks when the Micro adjust function and the Font selection are enabled or the printhead is
in the overheated condition.
2. Paper Out ( Red )
Comes On when the printer is in the Paper out condition.
Blinks when the paper eject error has occurred .
Tear Off / Bin ( Green )
3.
Blinks when the continuos paper is in the tear off position.
Comes On when the CSF Bin1 is selected, and goes Off when the CSF Bin2 is selected.
4. Font ( Green )
Indicates the font selections.
Printer status
Pause
Paper out error
Release lever error
Paper eject warning
Head hot warning
Micro adjust & Font selection
Tear off
Bin selection
Font selection
Fatal error

1.2.4 Buzzer

This printer has the buzzer to indicate its current condition with the following indications:
Paper out error
Release lever error
Paper eject warning
Illegal panel operation
Note: The symbols used in the table represents the following:
O
" " = A beep sounds for approximately 100 ms with the interval of approximately 100 ms.
" – " = A beep sounds for approximately 500ms with the interval of approximately 100ms.
Rev.B
Table 1-10. LED Status
Font
According as
font selection
Blinks
Table 1-11. Buzzer Status
Printer status
FX-1880/880 Service Manual
Chapter 1 Product Description
Tear-Off /
Pause
Bin
Blinks
Blinks
According as
paper path
According as
bin selection
Blinks Blinks
Beep sounds
OOO
– – – – –
OOO
O
Paper Out
On
On On
On
On Blinks
Blinks
Blinks
1-9