Table of Contents
Advertisement
10. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor
or switch. Connect one end of the chassis intrusion sensor or switch
cable to this connector. The chassis intrusion sensor or switch sends
a high-level signal to this connector when a chassis component
is removed or replaced. The signal is then generated as a chassis
intrusion event.
By default, the pin labeled "Chassis Signal" and "Ground" are shorted
with a jumper cap. Remove the jumper caps only when you intend to
use the chassis intrusion detection feature.
P5K-VM Chassis intrusion connector
11. Front panel audio connector (10-1 pin AAFP)
This connector is for a chassis-mounted front panel audio I/O module
that supports either HD Audio or legacy AC`97 audio standard.
Connect one end of the front panel audio I/O module cable to this
connector.
P5K-VM Analog front panel connector
•
We recommend that you connect a high-definition front panel audio
module to this connector to avail of the motherboard's high-definition
audio capability.
•
If you want to connect a high-definition front panel audio module
to this connector, set the Front Panel Type item in the BIOS setup
to [HD Audio]; if you want to connect an AC'97 front panel audio
module to this connector, set the item to [AC'97]. By default, this
connector is set to [HD Audio]. See section 2.4.5 Onboard Devices
Configuration for details.
ASUS V-Series P5G33
CHASSIS
(Default)
AAFP
SENSE2_RETUR
PORT2 L
SENSE_SEND
SENSE1_RETUR
PORT2 R
PRESENCE#
PORT1 R
GND
PORT1 L
NC
Line out_L
NC
NC
Line out_R
NC
MICPWR
AGND
MIC2
HD Audio-compliant
pin definition
Legacy AC '97 audio
pin definition
4-11
Advertisement
Table of Contents
