Table of Contents
Advertisement
Selecting a stage
point on the map...
Defining the radius around the stage points and the corridor width
Defining the radius
around the stage
points...
Defining the corridor
width...
Additional software: MapExport
1. On the map, search for the place or Point of Interest you want
to set as stage point.
2. Click the Stage point icon.
The mouse pointer becomes an arrow with a small flag.
3. Click the desired place (or Point of Interest) to add it to the
list of stage points.
The address (or Point of Interest) will be added to the list of
stage points. On the map, a small flag will indicate the stage
point with the number of its position on the itinerary.
Notice: If you click a place which is not accessible by car, the
nearest accessible place will be taken over as stage point.
A circle with a determined radius around the stage points will be
exported with the corridor. This grants navigation in the
neighborhood of the stage points, even outside the calculated
route.
1. Enter the desired value for the radius into the Radius entry
field. Values between 2 miles and 150 miles are allowed.
2. Enter the desired value for the corridor width into the
Corridor width entry field. Values between 1 mile and 60
miles are allowed.
If you leave the calculated route, a new route may be calculated
within the selected corridor (and within the selected circles
around the stage points).
User's manual OnCourse Navigator | 4
- 83 -
Advertisement
Table of Contents
