Replacing The System Board - Dell SmartStep 100N Replacement Manual

FILE LOCATION: C:\webworks\projects\tangedoc\source\sysboard.fm
DE LL CO NF I DE NTI A L – PR E LI M I N ARY 3/11 /02
6 Sy s t e m Bo a r d
1
3
1
video-connector hex nuts
2
parallel-connector hex nuts
3
headphone/microphone flex-panel
Remove the two hex nuts that secure the video connector to the
18
bottom case.
Remove the two hex nuts that secure the parallel connector to the
19
bottom case.
Pull the headphone/microphone flex-panel away from the system
20
board as you simultaneously lift the front of the system board out and
away from the bottom case.

Replacing the System Board

Install the replacement system board:
1
Insert the video connector through the back of the bottom case.
a
Pull the headphone and microphone flex-panel away from the
b
system board as you simultaneously lower the front of the system
board into the bottom case.
Press the flex panel toward the headphone and microphone
c
connectors, and insert the bridge into the bottom case.
2