Sony STR-DA5800ES Operating Instructions Manual page 140

When you try to use the One-Touch
Play function, input is not switched as
intended.
• Check to see if "Zone2 Out" is set to "Off."
• Check the assignment of the HDMI input
(page 89). When you assign multiple
inputs to the same HDMI input jack, if you
use the One-Touch Play function on the
equipment connected to the HDMI input,
the input you have assigned last is
preferentially selected.
The Audio Return Channel (ARC) does
not work.
• Make sure "Control for HDMI" is set to
"On" in the HDMI Settings menu.
• Make sure that the INPUT MODE for
"TV" is set to "AUTO" (page 88).
Remote control
The remote control does not function.
• Point the remote control at the remote
sensor on the receiver (page 11).
• Remove any obstacles in the path between
the remote control and the receiver.
• Replace all the batteries in the remote
control with new ones, if they are weak.
• When you start operating the receiver,
make sure to press AMP on the remote
control first. Otherwise, operations that
follow may not be aimed at the receiver.
Then select the devices you want to use by
pressing one of the input buttons.
• Make sure that the command modes of the
receiver and the remote control are the
same. If the command mode of the
receiver and the remote control are
different, you cannot operate the receiver
with the remote control (page 93).
• Make sure you select the correct input on
the remote control.
If the trouble is other than one of the cases
described above and the trouble is not solved
even if you wait for a while, perform either of
the operations below.
140
US
• Press ?/1 on the remote control to turn the
receiver off and then on again.
• Hold down ?/1 on the receiver until the
lamp above the button flashes in green to
reboot the receiver.
Universal Remote Control
The Universal Remote Control function
does not work.
• Make sure the connections required are
made.
If the trouble is other than one of the cases
described above and the trouble is not
solved even if you wait for a while,
perform either of the operations below.
• Press ?/1 on the remote control to turn the
receiver off and then on again.
• Hold down ?/1 on the receiver until the
lamp above the button flashes in green to
reboot the receiver.
• If the remote sensor of the receiver and
that of another Sony product face the same
direction, interference may occur. In this
case, set the remote sensors so that they
face different directions or use an IR shield
on the other Sony product to shield the IR
from interference from the receiver IR
remote.
• Make sure the receiver is connected to the
Internet.
• Press ROOM OFF on the remote control to
turn off the receiver and the AV
equipment.
Lighting Control
The lighting device cannot be
identified.
• Try pressing the button on the top of the
lighting device 4 times. Then repeat this
procedure more than once.
• If the LED continues blinking weakly,
press and hold the button on the lighting
device for 5 seconds then tap four times on
the button on the wizard.