Adjusting Setup Items - Sony MEX-BT3000 Operating Instructions Manual

AUX VOL (AUX Volume level)*
Adjusts the volume level for each
connected auxiliary equipment: "+18
dB" – "0 dB" – "–8 dB."
This setting negates the need to adjust
the volume level between sources.
BTA VOL (Bluetooth Audio Volume
Level)* (page 19)
4
*1 When EQ3 is activated (page 21).
*2 When the audio output is set to "SUB-OUT"
(page 22).
"ATT" is displayed at the lowest setting, and
can be adjusted up to 21 steps.
*3 When AUX source is activated (page 23).
*4 When Bluetooth audio source is activated.
Selecting the sound quality
— EQ3 Preset
You can select an equalizer curve from 7
equalizer curves (XPLOD, VOCAL, EDGE,
CRUISE, SPACE, GRAVITY, CUSTOM or
OFF).
1
During reception/playback, press the
select button.
2
Rotate the control dial until "EQ3
PRESET" appears, then press it.
3
Rotate the control dial until the desired
equalizer curve appears, then press it.
4
Press (BACK).
To cancel the equalizer curve, select "OFF"
in step 3.
Tip
The equalizer curve setting can be memorized for
each source.
3 Customizing the equalizer
curve — EQ3
"CUSTOM" of EQ3 allows you to make
your own equalizer settings.
1
2
3
4

Adjusting setup items

1
2
3
4
* For CLOCK-ADJ and BTM settings, step 4 is
not necessary. And for BT SIGNL and
PAIRING settings, step 3 and 4 are not
necessary.
The following items can be set depending
on the source and setting:
Select a source, then press the select
button.
Rotate the control dial until "EQ3
LOW," "EQ3 MID" or "EQ3 HIGH"
appears, then press it.
Rotate the control dial to adjust the
volume level, then press it.
The volume level is adjustable in 1 dB
steps, from –10 dB to +10 dB.
Repeat steps 2 and 3 to adjust the
equalizer curve.
To restore the factory-set equalizer
curve, press and hold the select button
before the setting is complete.
Press (BACK).
Press and hold the select button.
The setup display appears.
Rotate the control dial until the desired
item appears, then press it.
Rotate the control dial to select the
setting, then press it.*
The setting is complete.
Press (BACK).
21