Changing The Size Of A Fax - Sharp MX-M503U Quick Start Manual

CHANGING THE SIZE OF A FAX

The size of the original and the transmission size can be specified before transmission.
This is convenient when faxing an original that is small and difficult to read.
The procedure for faxing both sides of an A4 original at A3 size is explained below.
The side to be scanned must be face up!
Fax
Auto
Mode Switch
Exposure
Image
Settings
Standard
(1) Resolution
Memory TX
Direct TX
Auto A4
Original
Auto Reception
Fax Memory:100%
(2)
Fax
Scan Size
Original
Auto A4
2-Sided
Booklet
(3)
2-Sided
Tablet
Fax
AB
Original
Auto
A5
Manual A5R
B5
A4
Fax
Scan Size
Original
Auto A4
2-Sided
Booklet
2-Sided
Tablet
56
Address Book
Sub Address
Special Modes
File
Special Modes
Quick File
OK
100%
Send Size
Auto
(4)
Image Orientation
OK
Inch
(6)
B5R 216x340
B4
A4
A3 216x343
(5)
A4R
OK
141% Send Size
(7)
A3
Image Orientation
1
Place the originals.
When using the document glass, place the
original with the side to be scanned face down.
2
Select the original size settings in
the touch panel.
(1) Touch the [Image Settings] key.
(2) Touch the [Original] key.
(3) Touch the [2-Sided Booklet] key.
This key is used to send a 2-sided original.
(4) Touch the [Send Size] key.
(5) Touch the desired send size key
(example: A3).
(6) Touch the [OK] key.
(7) Touch the [OK] key.
3
Enter the fax number of the first
destination and press the [START]
key.
Correct a mistake Cancel scanning