Table of Contents
Advertisement
Speaker: routes the phone's audio through either the speaker or
•
through the earpiece.
– Tap Speaker to route the audio through the speaker. (You can adjust
the speaker volume using the volume keys.) A green line will appear
under the Speaker button.
– Tap Speaker again to use the phone's earpiece (see "Using the
Speakerphone During an Active Call" on page 47.) The green line
will turn grey when Speaker is not activated.
Mute: turn the onboard microphone either on or off.
•
– Tap Mute during a call to mute the microphone. A green line will
appear under the Mute button.
– Tap Mute again to unmute the microphone. The green line will turn
grey when Mute is not activated.
•
Headset: connects to a Bluetooth headset.
– Tap Headset during a call to activate a Bluetooth headset. A green line
will appear under the Headset button.
– Tap Headset again to de-activate the Bluetooth headset. The green line
will turn grey when the Headset is not activated.
•
Press
for more options:
– Contacts: allows you to go to your Contact list.
– Memo: allows you to jot down a memo during a call.
– Noise suppression on/off: allows you to turn on the Noise
Suppression feature when you are in a noisy area. Turn it Off when not
needed to conserve battery power.
45
Placing a Call on Hold
You can place the current call on hold at any point during a
conversation. You can also make another call while you have a
call in progress if your network supports this service.
While on a call, tap Hold
1.
current caller on hold (which is displayed on-screen as a
greyed-out box).
You can later reactivate this call by tapping Unhold.
2.
To make a new call while you have a call in progress
Tap Hold
.
1.
Tap Add call
to display the dialer.
2.
Enter the new number and tap
3.
Once connected, the active call will appear in a large box
in the middle of your screen and the call on hold will
appear in a small box in the upper right corner of your
screen.
Switching Between Calls
When you have an active call and a call on hold, you may switch
between the two calls, changing the one on hold to active and
placing the other on hold.
. This action places the
.
Advertisement
Table of Contents
