Restoring Factory Default Settings; Specifications - Garmin GBT 10 Bennett Trim Tab Adapter Installation and Configuration Installation And Configuration Manual

10. To enter an additional, optional trim tab position, move both trim tabs to a new position, and
observe the trim tab position as a percentage of the full range of motion of the trim tab.
11. Enter the following command: "TRIMTABPOS="
12. After the command, enter the percentage of the trim tab position as a whole number
between 0 and 100, and select Done. For example, TRIMTABPOS=50Done.
13. Repeat steps 10 through 12 to enter additional, optional trim tab positions.

Restoring Factory Default Settings

You will lose all custom configuration settings when you restore factory default settings.
1. From the NMEA 2000 Devices list, select the GBT 10 device.
2. Select an option:
• For most Garmin chartplotters, select
• For other Garmin marine devices, select
3. Select Yes.

Specifications

Physical
Weight: 12.85 oz. (365 g)
Size: (W × H × L)
31
total Cable Length: 16 ft. (4.9 m)
Case Material: Thermoplastic rubber (PCB overmold); PVC jacket (cable); PVC overmold
(connectors/strain reliefs). Waterproof to IEC 529 IPX7 standards.
temperature Range: From 5°F to 158°F (from -15°C to 70°C)
Compass Safe Distance: 2 in. (5 cm)
Electrical
Power input Source: 9–16 Vdc from the NMEA 2000 bus
nMea 2000 Power usage: 0.9 W max
nMea 2000 Load equivalency number (Len): 1 (50 mA)
Communications
Use this table to determine the approved NMEA 2000 PGN information that is transmitted and
received the GBT 10 adapter during communication with a NMEA 2000-compliant device.
Transmit
059392 ISO Acknowledgment
060928 ISO Address Claim
126208 NMEA - Command/Request/
Acknowledge Group Function
126464 Transmit/Receive PGN List Group
Function
126996 Product Information
130576 Small Craft Status
GBT 10 Installation and Configuration Instructions
× × 3 in. (24.7 × 17.0 × 78.6 mm)
/ / /
43 3
32 64 32
Review > Factory
Config > Factory
Receive
059392 ISO Acknowledgment
059904 ISO Request
060928 ISO Address Claim
126208 NMEA - Command/Request/
Acknowledge Group Function
Defaults.
Defaults.
The GBT 10 is NMEA 2000
certified