Restoring Factory Default Settings - Garmin GET 10, Engine Tilt Adapter Installation and Configuration Installation And Configuration Manual

Hide thumbs

Table of Contents

To configure the engine number if the menu option is not displayed:

If your boat has multiple engines, you can indicate which engine each GET 10 adapter is

associated with.

1. From the NMEA 2000 Devices list, select the GET 10 device.

2. Select an option:

•

For most Garmin chartplotters, select

•

For other Garmin marine devices, select

3. Enter the following command: "INSTANCE="

4. After the command, enter a whole number between 1 and 253, which indicates the engine

number, followed by Done. For example, INSTANCE=2Done indicates that the adapter is

associated with engine number 2.

To configure the gauge type if the menu option is not displayed:

When connected to a gauge, the GET 10 adapter gauge type is set to auto Detect by

default, and the adapter automatically detects the type of gauge it is connected to. When

you troubleshoot the gauge-type setting, if the engine-tilt reading on a connected Garmin

chartplotter or marine instrument changes with the engine RPM, the adapter may be detecting

the wrong type of gauge.

1. From the NMEA 2000 Devices list, select the GET 10 device.

2. Select an option:

•

For most Garmin chartplotters, select

•

For other Garmin marine devices, select

3. Enter the following command: "GAUGETYPE="

4. After the command, enter one of the following options:

•

To automatically detect the gauge type, enter 0, followed by Done. For example,

GAUGETYPE=0Done.

•

To indicate a one-coil gauge, enter 1, followed by Done. For example,

GAUGETYPE=1Done.

•

To indicate a two-coil gauge, enter 2, followed by Done. For example,

GAUGETYPE=2Done.