Epson P-3000 Multimedia Storage Viewer User Manual page 86

P-3000 User's Guide
Do not use a damaged or frayed AC adapter.
If you use an extension cord with the viewer, make sure the total amperage of all
devices plugged into the extension cord does not exceed the cord's amperage rating.
Never disassemble, modify, or attempt to repair the AC adapter by yourself except as
specifically explained in this guide.
Do not use power outlets controlled by wall switches or automatic timers.
Do not use power outlets on the same circuit as large motors or other appliances that
may cause voltage fluctuations.
Avoid using outlets on the same circuit as photocopiers or air control systems that
regularly switch on and off.
To prevent fire or electric shock, do not cover the AC adapter with a blanket or similar
covering.
Position the viewer's power cable so that it will not be stepped on or run over.
Do not place any objects on the power cable and the AC adapter.
Keep the power cable straight at the ends and at the points where it enters the
transformer.
The power cable should be placed so as to avoid abrasions, cuts, fraying, crimping,
kinking, and other damage.
If the AC plug does not fit your outlet, have a proper outlet installed by a qualified
electrician.
Remove the AC plug from the outlet during lightning storms.
For US and Canadian users:
Use the included power cord or a 6 to 10 foot UL-approved type SPT-2 or heavier type, 2
18 AWG cord with a 125 V 10 A plug and 125 V 7 A connector.
When using a memory card
Only memory cards designed for the viewer's specifications can be used.
Do not remove a memory card or turn off the viewer while the Access lamp is flashing.
See "Parts" (page 9) to find where the Access lamp is.
86
Appendix