Loading Envelopes - Epson WorkForce Pro WP-M4015 User Manual

User's Guide
D
Fan a stack of paper, then tap it on a flat surface to even the edges.
E
Load paper with the printable side up, at the center of the rear MP tray. The printable side is often whiter or
brighter than the other side.
F
Slide the edge guide to the edge of the paper, but not too tightly.
Note:
❏ After loading paper, set the paper size for each paper source. Paper is fed from the appropriate paper source
depending on the setting. Use the panel utility to set the paper size.
"Paper Size Loaded Setting" on page 66
&
❏ For plain paper, do not load paper above the line just under the d arrow mark inside the edge guide. For Epson
special media, make sure the number of sheets is less than the limit specified for the media.
"Selecting which tray to use and its loading capacities" on page 16
&
❏ Up to 1 sheet of Legal-size paper can be loaded at a time.

Loading Envelopes

Follow these steps to load envelopes:
Note:
The illustrations in this section are from a similar product model. Although they may differ from your actual product, the
method of operation is the same.
Paper Handling
22