Troubleshooting - Dynex DX-M1114 User Manual

8

Troubleshooting

Caution: Do not open the open the receiver case or
microphone housing. There are no user serviceable parts
inside.
Symptom
Receiver is turned on, but POWER
indicator does not light.
The AUDIO indicator lights when
speaking into the microphone,
but there is no sound.
The signal range is too small.
Sound quality is poor.
Troubleshooting
Possible solution
• Make sure that the batteries are installed correctly.
You must match the + and – symbols on the batteries
with the + and – symbols in the battery
compartment.
• Make sure that the batteries have a charge. Change
the batteries, if necessary.
• Make sure that the volume control on the amplifier is
not set too low.
• Make sure that the audio cable is connected securely
to the receiver and amplifier.
• Make sure that the antenna is fully extended.
• Make sure that the batteries are installed correctly.
You must match the + and – symbols on the batteries
with the + and – symbols in the battery
compartment.
• Make sure that the batteries have a charge. Change
the batteries, if necessary.
• Make sure that the receiver or microphone are not
located within a magnetic field.
• Make sure that the batteries are installed correctly.
You must match the + and – symbols on the batteries
with the + and – symbols in the battery
compartment.
• Make sure that the batteries have a charge. Change
the batteries, if necessary.
• Make sure that no other devices in the area are
operating on the same frequency as your wireless
microphone. Devices using the same frequency
should be at least 328 feet (100 meters) apart.