Preparation For Connection; Cable Connection; Wired Connection - Canon PIXMA PRO-100 Series Setup Manual

Wired Connection

a Preparation for Connection
Before Starting Wired Connection Setup
1. Make sure that the printer is turned on.
If the power is on, the POWER lamp (A) will be lit.
Notes on Wired Connection
• Make sure that the computer and router (A) (or access point) are connected.
• The confi guration, router functions, setup procedures and security settings of the network device vary depending on your
system environment. For details, refer to the manual of your network device or contact its manufacturer.
For offi ce use, consult your network administrator.
•
Take added care when connecting to a network that is not protected with security measures, as there is a risk of disclosing
•
data such as your personal information to a third party.
• This printer cannot be used over wireless and wired connections at the same time.
• When using a router, connect the printer and computer to the LAN side (same network segment).
b Cable Connection
You will need an Ethernet cable (sold separately).
1. Remove the Cap (A) from the upper port located on the right side at the back of the printer.