Table of Contents
Advertisement
5.
Secure the RAID card with the
screw that you removed earlier.
6.
Ensure that the data cables are
connected to the PSAS1 and
PSAS2 connectors.
7.
Ensure that the SGPIO_SEL1
jumper is set to pins 2-3. Refer to
2.7 SATAII/SAS backplane cabling
on page 2-19 for the jumper setting
details.
The heatsink on PIKE 2108 Series might interfere with the components on the
expansion card. Ensure that the height of the component is less than 5.8mm.
2-26
Chapter 2: Hardware setup
Advertisement
Table of Contents
