Table of Contents
Advertisement
5.
Note the correct alignment of the
back of the raiser card to the three
holes on the card bracket. Then
secure the Battery Backup Unit to
the bracket from the botton by using
the provided screws.
6.
Connect the other end of the cable to the PIKE card.
7.
Locate the PIKE RAID card slot on
the motherboard, then remove the
screw besides the PIKE slot.
8.
Insert the RAID card into the PIKE
RAID card slot. Ensure that it is
completely seated on the PIKE
RAID card slot.Align the golden
fingers of the RAID card with the
PIKE RAID card slot, then secure
the screw.
2-22
Chapter 2: Hardware setup
Advertisement
Table of Contents
