Chapter 2 W-620 Series Installation; Physical Installation; Tabletop Deployment; Initial Setup And Network Connectivity - Dell PowerConnect W-620 Installation Manual

The following tools and equipment are required for installation of a W-620 Series controller.
AC Power Cord (country-specific)
Any ethernet cables required for your deployment
Caution: Installation and service of Dell Networks products should be performed by Professional Installers. Additional antenna
and transmit power information for Professional Installers can be found at https://support.dell.com.

Physical Installation

Tabletop Deployment

To deploy an W-620 Series controller on a flat surface, such as a tabletop:
1. Insert the four rubber mounting feet to the bottom of the unit.
2. Place the unit on a hard flat surface.

Initial Setup and Network Connectivity

Once the physical installation is complete, run the initial setup on the controller to configure the IP address and
other basic system information. For complete details and instructions, refer to the Dell PowerConnect ArubaOS
Quick Start Guide for the software version installed on your controller.
Dell PowerConnect W-620 Controller | Installation Guide
Chapter 2
W-620 Series Installation
W-620 Series Installation | 13