Fujitsu MAP3147NC - Enterprise - Hard Drive Product/Maintenance Manual page 79
Disk drives
Hide thumbs
Also See for MAP3147NC - Enterprise - Hard Drive:
- Scsi logical interface specifications (290 pages) ,
- Installation manual (2 pages) ,
- Installation manual (2 pages)
Advertisement
5.3
Setting Terminals
A user sets up the following terminals and SCSI terminating resistor before installing the IDD in
the system as required.
Setting terminal:
Figures 5.2 shows the location of setting terminal. Figures 5.3 shows the allocation and default
settings.
Data loss
1.
The user must not change the setting of terminals not described in this
section. Do not change setting status set at factory shipment.
2.
Do not change the setting of terminals except following setting pins
during the power is turned on.
3.
To short the setting terminal, use the short plug attached when the device
is shipped from the factory.
Figure 5.2
C141-E166
CN2 (NP model only)
Write protect: CN2 9-10 (NP model only)
Setting terminals location (on NP models only)
CAUTION
Pin 2
CN2
Pin 1
Pin 23
Pin 24
5-5
Advertisement
