Watching Tv; Sleep Timer; Switching Each Input Mode; Freeze Mode - Magnavox 40MF430B - Owner's Manual

WATCHING TV

Sleep Timer

p
can be set to automatically turn off the unit after an incremental
period of time.
Press SLEEP repeatedly to change the amount of time (increases
the time by 30 minutes up to 120 minutes) until shut off.
Press SLEEP once to call up the display for checking the remaining time. P
To cancel sleep timer, press SLEEP repeatedly until
•
[Sleep Off] is displayed.

Switching Each Input Mode

between TV (ATSC or NTSC) and external devices when they are connected to the unit.
Press SOURCE or CH + repeatedly to cycle through the input modes.
e.g.)
Source
TV
Video1
Video2
DTV/TV channel
Component
HDMI1
HDMI2
HDMI3
HDMI3
• Pressing CH − reverses the direction of the input modes.

Freeze Mode

can freeze the image shown on the TV screen for 5 minutes.
Press FREEZE to freeze the image.
Freeze
• The sound output will not be paused.
• To cancel freeze mode, press any buttons except .

Channel Selection

Select channels by using CH + / − or the Number buttons.
•
To select the memorized channels,
use CH + / − or the Number buttons.
•
To select the non-memorized channels,
use the Number buttons.
To use the Number buttons
ATSC
.
-
When selecting digital channel 11.1
Be sure to press before entering the subchannel number.
NTSC
-
When selecting cable or analog channel 11
Press PREV CH to return to the previously viewed channel.
Note •
[No Signal] will appear on the TV screen after the subchannel broadcast is over.
•
[Audio only program] message will appear on the TV screen, when you receive
only sound signal.
16
EN
can easily switch with the remote control
11.1
Video1
HDMI2
Sleep 120min.
Video2 Component
HDMI1
(or PC input)
11.1