Watching Tv; Sleep Timer; Switching Each Input Mode; Freeze Mode - Magnavox 37MF301B Owner's Manual

12

WATCHING TV

Sleep Timer

p
can set the unit to go into standby mode after an incremental period of time.
Press SLEEP repeatedly to change the amount of time (increases
the time by 30 minutes up to 120 minutes).
Press SLEEP once to call up the display for checking the remaining time.
• To cancel sleep timer, press SLEEP repeatedly until [Sleep Off] is
displayed.

Switching Each Input Mode

between TV (ATSC or NTSC) and external devices when they are connected to the unit.
Press SOURCE or CH + repeatedly to cycle through the input modes.
e.g.)
Source
TV
HDMI1
DTV / TV channel
HDMI2
HDMI3
Component
Video
• Pressing CH − reverses the direction of the input modes.

Freeze Mode

can freeze the image shown on the TV screen for 5 minutes.
Press FREEZE to freeze the image.
Freeze
• The sound output will not be paused.
• To cancel freeze mode, press any buttons except .

Channel Selection

Select channels by using CH +/− or the Number buttons.
• To select the memorized channels,
use CH +/− or the Number buttons.
• To select the non-memorized channels,
use the Number buttons.
To use the Number buttons
ATSC
- When selecting digital channel 11.1
Be sure to press • before entering the subchannel number.
NTSC
- When selecting cable or analog channel 11
Press PREV CH to return to the previously viewed channel.
Note • [No Signal] will appear on the TV screen after the subchannel
broadcast is over.
• [Audio only program] message will appear on the TV screen, when you
receive only sound signal.
can easily switch with the remote control
11.1 HDMI1
(or PC Input)
Video Component
Sleep 120min.
HDMI2
HDMI3
11.1