Panasonic TH-L32C10 Operating Instructions Manual page 48

FAQs
Problem
Chaotic image, noisy
No image can be
displayed
Blurry or distorted image
(no sound or low volume)
Unusual image is displayed
No sound is produced
Sound level is low
or sound is distorted
Sound is unusual
Pictures from external
equipment are unusual
when the equipment is
connected via HDMI
TV goes into
"Standby mode"
The remote control
does not work
48
Set "P-NR" in the Picture Menu (to remove noise). (p. 20)
Check nearby electrical products
(car, motorcycle, fluorescent lamp).
Is "Colour" or "Contrast" in the Picture Menu set to
the minimum? (p. 20)
Check Colour System. (p. 27)
Check AV Colour System. (p. 21)
Reset channel. (p. 28)
Turn off the TV with Mains power On / Off switch,
then turn it on again.
Is "Sound mute" active? (p. 8)
Is the volume set to the minimum?
Sound signal reception may be deteriorated.
Check Sound system. (p. 27)
Set "MPX" (p. 20) in the Sound Menu to "Mono".
Set the sound setting of the connected equipment to
"2ch L.PCM".
Check the "HDMI1 Input" (or "HDMI Input" for
TH-L32C12K) setting in the Sound Menu. (p. 20)
If digital sound connection has a problem, select
analogue sound connection. (p. 43)
Is the HDMI cable connected properly? (p. 45)
Turn Off the TV and equipment, then turn them On
again.
Check an input signal from the equipment. (p. 46)
Use an equipment compliant with EIA/CEA-861/861B.
Off Timer function is activated.
The TV enters "Standby mode" about 30 min. after
broadcasting ends.
Are the batteries installed correctly? (p. 6)
Has the TV been switched On?
Has the battery run down?
Actions