Nokia CR-99 - Cell Phone charger/holder User Manual page 4

screw, and replace the protection
plate (see Figure 1 on the title page).
When you attach the holder, ensure
that the display of the mobile device is
Set up
You can use a compatible charger
with a mobile device that is placed in
the holder. For this purpose, the holder
is supplied with two nuts of different
sizes. If the arms of the holder cover
the side keys of your mobile device
when using the preinstalled nut, use
the other nut instead.
Push the release buttons at the sides
of the holder to expand the arms to
the maximum width (2).
If the charger connector is located at
the bottom of your mobile device,
remove the locking catch by pulling it
from the holder, and push the nut
through the ring to detach it (3A).
clearly visible for the user. For your
safety, install the holder in the upright
position.
Insert the charger cable into the slot
in the nut (3B). Push the nut into the
ring (3C). Attach the locking catch
(3D).
If the charger connector is not located
at the bottom of your mobile device,
remove the locking catch, and push
the nut through the ring (4A). Loop
the charger cable onto the nut (4B);
adjust the charger plug so that it
reaches to the charger connector on
your mobile device. Push the nut into
the ring (4C). Attach the locking catch
(4D).
ENGLISH