Magnavox MBP5230 Owner's Manual page 52

Manual (Wired)
In the following cases, select "Manual"(wired) to set each setting as necessary.
- When connection test failed with the setting of "Auto"(wired).
- When instructed by your Internet service provider to make specific settings in accordance with your network
environment.
1. Follow steps 1 to 2 in "Auto (Wired)" on page 51.
2. Use [Î / ï] to select "Manual", then press [OK].
3. Use [Î / ï] to select "IP Address", then press [OK].
4. IP address setting screen will appear. Enter IP address with cursor buttons and number buttons.
Network Settings (Manual)
IP Address
Please input the IP Address.
0 . 0 . 0 . 0
Next e ext ext e t Back Clear OK
Cancel nce nce nce ncel cel l l l l
5/7
• Enter the IP address after checking the specifications of your router.
• If the IP address is unknown, check the IP address of other devices. (e.g. PC connected via LAN cable) and
assign a different number from those of other devices.
5. Use [Î / ï / Í / Æ] to select "OK", then press [OK].
6. Select "Subnet Mask", "Default Gateway", "Primary DNS" and "Secondary DNS" in turn, and enter each address
number with cursor buttons and number buttons, then press [OK].
• Enter the DNS addresses provided by your Internet provider.
• If the DNS address is unknown, check the DNS address of other devices (e.g. PC connected via LAN cable)
and assign the same DNS address.
Network Setting s (Manual)
Please enter your network settings.
IP Address :
Subnet Mask :
Default Gateway :
Primary DNS :
Secondary DNS :
Next
Cancel
5/7
7. Use [Î / ï / Í / Æ] to select "OK", then press [OK].
8. Use [Î / ï / Í / Æ] to select "Next", then press [OK].
9. Use [Î / ï] to select "Yes" or "No" for proxy server, then press [OK].
• If you use proxy server, select "Yes" to go to the next step.
• If you do not use proxy server, select "No" to go to step 13.
EN-52
xxx. xxx. xxx. xxx
xxx. xxx. xxx. xxx
xxx. xxx. xxx. xxx
xxx. xxx. xxx. xxx
xxx. xxx. xxx. xxx
Continued on next page.