Panasonic DMC FS7G - Lumix Digital Camera Operating Instructions Manual page 25

x [USB MODE]
• When [PC] is selected, the camera is connected via the "USB Mass Storage" communication
system.
• When [PictBridge(PTP)] is selected, the camera is connected via the "PTP (Picture Transfer
Protocol)" communication system.
[TV ASPECT]
• This will work when the AV cable (P88) is connected.
[VERSION DISP.]
[FORMAT]
• Use a battery with sufficient battery power or the AC adaptor (DMW-AC5PP; optional) and DC
coupler (DMW-DCC4; optional) when formatting. Do not turn the camera off during formatting.
• If a card has been inserted, only the card is formatted. To format the built-in memory, remove
the card.
• If the card has been formatted on a PC or other equipment, format it on the camera again.
• It may take longer to format the built-in memory than the card.
• If the built-in memory or the card cannot be formatted, consult your nearest Service Center.
For USA and Puerto Rico assistance, please call:
1-800-211-PANA(7262) or, contact us via the web at:
http://www.panasonic.com/contactinfo
Select the USB communication system after or before connecting
the camera to your PC or your printer with the USB connection
cable (supplied).
y [SELECT ON CONNECTION]:
Select either [PC] or [PictBridge(PTP)] if you connected the
camera to a PC or a printer supporting PictBridge.
{ [PictBridge(PTP)]:
Set after or before connecting to a printer supporting PictBridge.
z [PC]:
Set after or before connecting to a PC.
Set to match the type of TV.
(Playback mode only)
[W]: When connecting to a 16:9 screen TV.
[X]: When connecting to a 4:3 screen TV.
It is possible to check which version of
firmware is on the camera.
The built-in memory or card is formatted. Formatting irretrievably
deletes all the data so check the data carefully before formatting.
For Canadian assistance, please call:
1-800-99-LUMIX (1-800-995-8649) or
send e-mail to: lumixconcierge@ca.panasonic.com
Preparation
25
VQT2C70