Remote Control - Sony STR-DA2800ES Operating Instructions Manual

"BRAVIA" Sync (Control for
HDMI)
"Control for HDMI" cannot be set to
"On."
• Set "Zone2 Out" in the "HDMI Settings"
to "Off."
The Control for HDMI function does not
work.
• Check the HDMI connection (page 27, 29,
31, 32).
• Make sure "Control for HDMI" is set to
"On" in the HDMI Settings menu.
• When "Zone2 Out" is set to "On," the
Control for HDMI function does not work.
• Make sure the connected equipment is
compatible with the Control for HDMI
function.
• Check the Control for HDMI settings on
the connected equipment. Refer to the
operating instructions of the connected
equipment.
• If you change the HDMI connection,
connect/disconnect the AC power cord
(mains lead), or there is a power failure,
repeat the procedures of "Preparing for the
"BRAVIA" Sync" (page 78).
• When you select "HDMI OUT B" or
"OFF," the Control for HDMI function
does not work properly.
• If you select "HDMI OUT A" after you
have selected "HDMI OUT B" or "OFF,"
the Control for HDMI function may not
work properly for a while. This is because
the equipment connected to the HDMI
OUT A jack must re-recognize the
receiver that is equipped with the Control
for HDMI function. If the Control for
HDMI function does not work properly for
a long time, perform the steps given in
"Preparing for the "BRAVIA" Sync"
(page 78).
• The types and the number of devices
which can be controlled by the "BRAVIA"
Sync feature are restricted in the HDMI
CEC standard as follows.
128
US
– Recording equipment (Blu-ray Disc
recorder, DVD recorder, etc.): up to 3
devices
– Playback equipment (Blu-ray Disc
Player, DVD player, etc.): up to 3
devices
– Tuner-related equipment: up to 4
devices (The receiver uses one of them
for its GUI operations.)
– Audio System (AV Receiver): up to 1
devices
When you try to use the One-Touch
Play function, input is not switched as
intended.
• Check to see if "Zone2 Out" is set to "Off."
• Check the assignment of the HDMI input
(page 83). When you assign multiple
inputs to the same HDMI input jack, if you
use the One-Touch Play function on the
equipment connected to the HDMI input,
the input you have assigned last is
preferentially selected.
The Audio Return Channel (ARC) does
not work.
• Make sure "Control for HDMI" is set to
"On" in the HDMI Settings menu.
• Make sure that the INPUT MODE for
"TV" is set to "AUTO" (page 82).

Remote control

The remote control does not function.
• Point the remote control at the remote
sensor on the receiver (page 11).
• Remove any obstacles in the path between
the remote control and the receiver.
• Replace all the batteries in the remote
control with new ones, if they are weak.
• When you start operating the receiver,
make sure to press AMP on the remote
control first. Otherwise, operations that
follow may not be aimed at the receiver.
Then select the devices you want to use by
pressing one of the input buttons.